Locline is a superior way to deliver recirculated wort and sparge water onto the top of the grainbed.Ġ of 0 people found the following review helpful: Note: The plain locline segment WILL snap directly over the hose barb you find on the Blichmann AutoSparge unit. Lastly, if you want to build something with these locline parts in some configuration we have not conceived, we are also offering locline components ala carte as well as the handy tool that makes snapping the pieces together a lot easier. We do offer an additional "sparge ring" assembly that can be snapped on to the bottom of one of the above vertical drop assemblies for those brewers who feel better about sprinkling the sparge water in a more spread pattern. We've put together three common assemblies that will work for most mash tun vessels for both mash recirculation and sparging. This kit comes standard with 16 straight links for a height drop of about 13" when the bottom is curved to horizontal. This kit is shown on the far right of the picture. It will also work with Rubbermaid/Gott cooler lids, but you can acheive a lower profile with the regular weldless kit if you make the hole at a location where the top and bottom plastic gets close together. This kit will work with lids that are up up to about 1.5" thick, e.g. You can then put either a hose barb or camlock type F (either sold separately) into the top of the coupling. Drill a 7/8" hole in the underside of the lid and a 1-1/8" hole in the topside of the lid for the coupling to fit into. It comes with a metal washer, silicone gasket and 1/2" NPT coupling. Weldless Kit for Thick Cooler Lids - This kit deletes the lockline elbow so that the straight connector is inline with the tube.Of course this only works if you're subscribed to the use of BLQD style Quick Disconnects for your disconnect system.(THIS option is not shown in any of the pictures) Add teflon tape to the threads and thread on the BLQD Type A Fitting. Weldless Kit with BLQD-A After drilling a 7/8" hole in the top sidewall of your metal mashtun or through the lid, use the SS washer and silicone flat on the inside.It provides a maximum vertical drop of about 12" with the last two links bent to horizontal. Of course this only works if you're subscribed to the use of Cam Locks for your disconnect system.(THIS option is shown in the middle of the picture). Add teflon tape to the threads and thread on the Camlock Type A Fitting. After drilling a 7/8" hole in the top sidewall of your metal mashtun or through the lid, use the SS washer and silicone flat on the inside. Note, we do not include the 90 degree plastic fitting anymore but we added two additional straight links and lowered the price as the straight links can be bent pretty sharply anyway.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |